I picked my black currants. My little bush produced almost a gallon of berries. By themselves they weren't that sweet, but in jelly? Delicious!
So, if you're lucky enough to have fresh currants (or gooseberries or nanking cherries or anything similar), make some jelly. It's worth the time and effort. Here's my step-by-step process:
1. Pick the berries. Pretty self-explanatory.
2. Wash the berries. Pick out the spiders and slugs and other creepy crawlies. Get rid of the dead leaves and stems. Get them as clean as you can.
3. Dump them into a large pot. Add just enough water to cover the berries. Bring it to a boil, turn down the heat and simmer for 10 minutes.
4. Remove from the heat, cover, and let them sit for a couple of hours.
5. Use a big spoon and smash the berries. Don't worry too much about the seeds and skins and stuff, you want to free up as much juice and flavor as you can at this point.
6. Place a large colander over a large bowl. Once you've smashed the berries, pour the berry smash through the colander to strain out the seeds and skins and stuff. You want just the juice. Leave the colander over the bowl and let the juice keep dripping for an hour or so. Stir the berries every once in a while to help the juice get through.
7. Once you have the juice strained, measure it and figure out how much jelly you need to make. At this point, follow the directions on your pectin. I'm really liking the Ball pectin in the large jars. For jelly with that, you need 1 1/3 c. juice, 1 1/2 T powdered pectin, and 1 1/2 c. sugar for each pint of jelly. Don't make a batch larger than 7-8 pints, though. Even if you have a giant pot that won't boil over with that much juice and sugar in it, it's hard to get the pectin and sugar to completely dissolve and cook right. The jelly won't set right, so just do multiple batches if you have more than a couple of quarts of juice.
8. Figure out how many pints you are going to need, then add one. Put that many clean jars in a sink full of really hot water. (If you're using smaller jars, figure out how many you will need. I don't recommend jars larger than a pint for jelly. It doesn't set right in the quart jars.)
9. Once you have the juice measured out, stir in the pectin. Cook it over high heat to a full rolling boil, it should keep boiling even after you stir it. Dump in the sugar all at once. Cook and stir over high heat until it comes to a full boil again. Boil and stir for 1 minute. Turn off the heat, move the jelly off the stove, and carefully pour into hot jars.
10. Wipe the rims of the jars clean, then seal and process following the directions for your altitude and your equipment. If you don't want to bother with this step, put the lids on the jars and let them cool on the counter. Once cool, refrigerate. Eat within a month or so.
Black currants make a wonderfully flavorful, deep red-purple jelly. I can't wait for next year and hopefully a whole lot currants.